orbis™ + a tiny flash = MORE great light
May 25, 2010 by admin
A while back someone asked me if you can get the great shadowless orbis™ ring flash look with the tiny Canon 270EX. I wasn’t immediately sure, so headed down to my friendly local camera store to find out. Turns out it fits ! And here are the photos to prove it….
As you can see, you need to hold it differently to a normal SLR flash, but it’s no problem at all. But I really wanted to see if it could shoot properly with the orbis™ too, as small flashes like this and the Nikon SB400 aren’t very powerful. So I grabbed my favourite camera Read more
manufacturing the orbis™
June 22, 2009 by admin
A rather abrupt comment appeared from an anonymous poster on one of our YouTube videos recently. It raised an important issue; that of the human rights implications of manufacturing in China. I do not take this issue lightly, so this is a welcome opportunity to discuss the reasons behind our choice to manufacture the orbis™ in China and the standards at the facility there. This post is fairly serious, so if you’ve just dropped by to check out some cool photo tips, you might want to take a look at some other blog entries or elsewhere around www.orbisflash.com.
When we began to research manufacturing the orbis™, Read more
orbis™ clip development
June 4, 2009 by admin
I thought it would be cool to give you an insight into some of the work that went into development of the orbis™ ringflash, with an occasional new feature in the blog. All these posts will use the ‘orbis™ tech’ category, so if you want to read the series, over time you’ll be able to see all related posts by clicking on the ‘orbis™ tech’ category at the bottom of this post.
First up is a detail in the development of the clip component. We decided early on that the orbis™ ring flash should fit as wide a range of flashes as possible. Now from a business perspective, this makes no sense. It would be much better for us if every time you bought a new flash or upgraded your existing flash, you had to buy another orbis™. But as a photographer, I avoid equipment that will only work with a particular setup; equipment will always have to be upgraded. So the flash retention system we devised with our product designers offers unparalleled flexibility. The only downside of that is that it is going to take a hammering, with repeated use.
We turned to a local university’s engineering department to build a bench testing device that would stress the orbis™ more than would occur in normal use, to over 10,000 cycles in 24 hours. Here’s a photo of the setup.
The end result was a perfect score ! We couldn’t get the clip to break, thanks to the innovative plastic and design technology we put into it. And even more importantly, after that heavy use, the clip was of course slightly more open than usual, but after leaving it for half an hour it had returned to its original shape and was as good as new. It’s worth remembering though, if you’re not using your orbis™ it’s best not to leave your flash attached, as detailed in the manual.
Just a bit of insight into the work that went into the orbis™. JM
Browse Posts
Archives
Join all the other orbis™ photographers on flickr®!
